Most people searching for used Knoll Morrison cubicles are not designing a new office. They are trying to add stations to a floor that already has Morrison, replace damaged components, or rebuild a team area after a reorganization. This page is written for that situation.
The matching problem with legacy systems
Morrison is a long-running Knoll panel system, and floors that use it were often furnished in phases. That creates a few practical challenges when you need more:
- Generational differences. Components from different eras may use different hardware or panel construction.
- Finish drift. Fabric and paint from an original order may have faded or been discontinued.
- Undocumented layouts. The original plans and part numbers are often long gone.
- Small quantities. Ordering five stations new may not be practical, and finishes may not match anyway.
Pre-owned inventory solves some of these problems because it comes from floors built with similar components. The key is documenting what you have before you shop.
What to measure and photograph first
A little prep up front prevents a truck arriving with panels that will not connect. Gather the following before requesting a quote:
- Panel heights from the floor to the top of the panel, including any stacked sections.
- Panel widths for each size in a typical station.
- Connector close-ups showing how two panels join in a straight run, an L and a T.
- Base power photos if the panels are electrified. Your electrician should review any power components before use.
- Worksurface sizes and how they attach: brackets, cantilevers or panel-hung.
- Fabric and paint photographed in natural light next to a white sheet of paper.
- Storage pieces such as overheads, pedestals and lateral files, with dimensions.
- A rough floor plan of where the new stations will go, including columns and outlets.
Email the photos and measurements to hello@officestation.com or use the quote builder. Free space planning can help confirm the new stations will fit the room.
Start a Morrison matching quote
Three ways to expand a Morrison floor
| Strategy | How it works | Tradeoff |
|---|---|---|
| Exact match | Source pre-owned Morrison in the same heights, sizes and similar finishes. | Depends on what inventory is available at the time |
| Frame match, finish contrast | Match panels and hardware, then use a deliberate accent fabric or topper. | Looks intentional, but it is visibly different |
| Separate zone | Place a different system in its own area, such as a new team neighborhood. | No connection to existing runs; needs its own layout |
An exact match is ideal when stations sit in the same run as existing ones. When new stations will be in a separate area, a different system can be more economical and faster to source.
Pricing and lead times
Use a 6'x6' workstation, furniture only, as your reference point:
- Liquidation-grade: $615, in as little as 72 hours when in stock
- Remanufactured: $1,245, usually 7 to 14 days
- New: $1,920, typically 4 to 6 weeks
Prices exclude electrical, delivery and professional installation. Installation is $95 per workstation with a $495 minimum. Greater Phoenix delivery is $195 central or $295 metro, and freight elsewhere in the country is quoted per project. Volume discounts apply at 20, 50 and 100 or more stations: 5%, 8% and 12%.
Pre-owned stations carry a condition grade. Grade A is like new, B is very good and C is good. For stations that will sit beside older furniture, a B or C grade may actually blend in better than a like-new station.
Planning install day for an occupied floor
Expansions usually happen next to people who are still working. A few steps keep the disruption low:
- Schedule around your team. Ask about after-hours or weekend installation if the new stations sit inside an active area.
- Clear the path. Confirm dock access, freight elevator times and any building rules before delivery.
- Stage by station. Label where each new station goes on the floor plan so parts are not left in a pile.
- Book the electrician. If the new runs tie into existing powered panels, have your electrician scheduled for right after the furniture goes in.
- Check the joins. Before the crew leaves, confirm the new panels sit plumb against existing runs with no gaps.
Warranty and reseller status
Office Station is an independent reseller of pre-owned Knoll furniture, not an authorized Knoll dealer. Manufacturer warranties generally do not transfer to pre-owned furniture. Treat the condition grade, photos and itemized component list as your basis for the purchase.
When it is time to retire Morrison
Sometimes the right move is to remove an aging Morrison floor entirely. If you are relocating or consolidating, Office Station can provide a written net offer: the resale value of the furniture minus removal cost. A positive number means you are paid.
Offers are delivered within 5 business days of a walkthrough. Services include nights and weekends crews, certificates of insurance for your building, e-waste handling with certificates of data destruction, and a photo-documented broom-clean handback with a diversion summary.
Related pages
- Used Knoll Dividends Horizon
- Pre-owned office furniture
- Corporate relocation
- Office furniture guides
Average market rate Prices subject to availability and project pricing.
Frequently asked questions
Why buy used Knoll Morrison instead of switching systems?
If you already have a floor of Morrison, adding a few stations of the same system keeps the look consistent and avoids reconfiguring everything around a new product. Pre-owned is often the most direct route to parts and stations for an established legacy system.
Will used Morrison panels connect to my existing panels?
They can when panel heights, widths and connection hardware match. Morrison has been produced in more than one generation and configuration, so send photos of your panels, connectors and power components before ordering so compatibility can be checked.
What does a used 6'x6' Morrison workstation cost?
As a reference for a 6'x6' workstation, furniture only: liquidation-grade about $615, remanufactured about $1,245 and new about $1,920. Your price depends on grade, components and finish, and excludes electrical, delivery and installation.
Does the Knoll warranty come with used Morrison cubicles?
Generally no. Office Station is an independent reseller, not an authorized Knoll dealer, and manufacturer warranties generally do not transfer to pre-owned furniture.
Can I get just parts rather than full stations?
Ask. Add-ons like worksurfaces, panels or storage may be available depending on current inventory. Include exact sizes and photos in your request so the right components can be identified.
Average market rate Prices subject to availability and project pricing.
